Are there any side-effects from using Wartner Wart Pen?

There are a number of possible side-effects:

  • Using Wartner Wart Pen Wart Pen may cause some discomfort (transient tingling, burning sensation)In case of small warts, there is higher chance of wounding or discomfort experience, therefore the application should be limited to 1 time a day.
  • Always use Wartner Wart Pen Wart Pen very carefully and accurately. If you’re not careful, scars and minor skin damage may occur.

I’ve tried Wartner Wart Pen once, but nothing happened, what do I do next?

For verrucas, which are more persistent and more difficult to treat, 2 extra steps are needed prior to the treatment. First, soak the foot in warm water for 5 minutes and then rub the callous carefully with a file (widely available for purchase) to expose the persistent verruca. Dry it thoroughly so there is no water/moisture between the wart and the Wartner TCA gel. Do not apply the TCA gel when the skin is bleeding or broken. File not included.

If there is no improvement after the first treatment period of 4 days, repeat the treatment after a break of 4 days, you can repeat this treatment schedule up to 4 times. If there is no improvement after the 4 treatment, please consult a doctor.

How do I use Wartner Wart Pen?

When the Pen is used for the first time, it is necessary to fully turn the dial on the top of the pen clockwise to load the gel into the brush tip until the first drop is visible. Several full turns might be needed as the gel is stored at the top of the Pen (to avoid leakage prior to first treatment).

STEP 1

Hold the pen vertically with the brush tip facing downwards. Slowly turn/click the dial on the top of the Pen clockwise to dispense the gel.

STEP 2

Allow the gel to flow into the brush tip for 3 to 5 seconds

STEP 3

Carefully apply the dispensed gel only on the wart or verruca (not on healthy skin surrounding it)

STEP 4

Let the gel dry for 10-15 minutes before putting on clothes or shoes.

The Wartner Pen formula is very concentrated and only one drop is needed per application. Carefully cover the entire surface of the wart and not the healthy skin surrounding it. Once the treatment is completed, carefully clean the pen with a tissue before storage.

 

2 ADDITIONAL STEPS FOR VERRUCAS for optimal preparation and after-treatment


PRIOR TO THE TREATMENT

First, soak the foot in warm water for 5 minutes and then rub the callous carefully with a file (widely available for purchase) to expose the verruca. Dry it thoroughly so there is no water/moisture between the wart and the Wartner TCA gel. Do not apply the TCA gel when the skin is bleeding or broken. File not included.

STEP 1-4

Same as for the removal of warts as above. Once treatment is complete, carefully clean the Wartner Pen with a tissue before storage.

How often may I use Wartner Wart Pen?

Wartner Wart Pen should be applied twice daily for 4 days. After this treatment of 4 days, the skin will peel off over the next 4 days. You can carefully remove the peeling skin under lukewarm water. After the treatment, new skin (free from warts) will form. The wart may disappear from the first week of treatment. If the wart does not disappear completely, repeat the treatment after a break of 4 days. You can repeat this treatment schedule up to 4 times.

If the wart (or verruca) is small (size of a needle point), only apply the gel once a day

How many times should I turn the twist-and-turn wheel before the first drop of TCA is released?

When the Wartner Wart Pen is used for the first time, it is necessary to fully turn the dial on the top of the pen clockwise to load the gel into the brush tip until the first drop is visible.  Several full turns might be needed as the gel is stored at the top of the Pen (to avoid leakage prior to first treatment)

Do not turn the dial more than the amount of times necessary to release 1 drop of formulation, as this may result in over-dispensing of TCA and smearing on normal skin, which might cause severe irritation of the area.

Is Wartner Wart Pen difficult to apply?

No. Wartner Wart Pen should be applied with precision, but it’s not difficult. The information leaflet explains exactly how you should apply Wartner Wart Pen.